Moving right along with the leading edges, today I began with upsizing the #40 pilot holes to #30 for the final rivet sizing. In the picture below is one of the leading edge pieces that is ready to be trimmed. In the picture below, I’m getting the nutplates located for the mid-hinge access panel. These […]

Today I’m working at adding the leading edges to the elevators. I’ve been putting this off as I don’t want to screw it up, so joining me today is my best bud Garet. We started with locating and pilot drilling the holes to attach the leading edges to the spar. Once all the holes were […]

Today I’m proceeding with the elevator balance weights and locating them on the elevators. In the picture below, I have the balance weight assembly roughly located on the elevator. You can also note that I previously made 3 vertical black lines. These black lines indicate the spacing of the 3 structural screws (AN525-10R7) which attach […]

Today I’m ready for a change of pace on the elevators and I’m going to start building up the balance weights. I’ve been putting this off for a while as I know it’s going to be a complicated event. However, like everything in building planes, the process becomes clear when you chunk it down and […]